The TxPower are the ones you need to change to set the transmit power and the nvram commit permanently saves these settings to the router. Note that the #a here is the country, #a is the “wildcard” country which enabled all channels supported by the hardware. Here you can enter the following commands but don’t blindly enter them! The last few tell you the transmission power and you probably don’t want it to be 500mW, but these are (as far as I know) the maximum supported: Secondly, after installing this you will need to connect either through telnet or through ssh.
WIFI TRANSMIT POWER INSTALL
The first thing you need to do is install the Merlin firmware version 374.43_2, newer ones won’t work! You can download the firmware from Merlin’s site:
But due note that this might not be legal in your country so please check how much you are allowed to transmit using this table. With many people living in modern houses which are essentially faraday cages not a lot of harm can be done by increasing the power a bit. Taking the above warning into consideration, the allowed transmit power depends on your location and any transmit licenses you might have. BIG WARNING: Increasing your router to it’s maximum power can reduce it’s life expectancy, cause problems for your neighbours, can be illegal depending on your location and in some cases even has the potential to cause actual dangerous situations since RADAR can share this frequency!
0 kommentar(er)
